Leprecon VX Series Non-Dim Programming Instructions Instrukcja Użytkownika Pobierz pdf (Strona 1)

Revised VX Software:

Allows any of the channels on the pack to be set for non-dim operation. The information, once set, is

stored in the pack memory and is retained permanently. Using a specific DMX switch setting sets the

channel operation. Once the switch is set, press the ‘enter’ switch on the front panel, or cycle power

to the dimmer.

There are two ways to make a channel a non-dim channel:

1) Set a single channel by setting the DMX code shown below, and press ‘enter’.

DMX Function

801 Channel 1 Non-dim

802 Channel 2 Non-dim

803 Channel 3 Non-dim

804 Channel 4 Non-dim

805 Channel 5 Non-dim

806 Channel 6 Non-dim

807 Channel 7 Non-dim

808 Channel 8 Non-dim

809 Channel 9 Non-dim

810 Channel 10 Non-dim

811 Channel 11 Non-dim

812 Channel 12 Non-dim

Setting 899 and pressing ‘enter’ clears all non-dim channels.

2) Set several channels at once. Connect a functioning console to the VX dimmer. Apply power. Set

the address to 800. Channels with levels above 10% will be programmed as non-dim. The settings

are memorized when ‘enter is pressed.

Setting 899 and pressing ‘enter’ clears all non-dim channels.

Revised VX Software: Allows any of the channels on the pack to be set for non-dim operation. The information, once set, is stored in the pack memor

Brak uwag

Leprecon VX Series Non-Dim Programming Instructions Instrukcja Użytkownika Strona 1